SUP Kit

Maintenance and support

SUP Kit

SUP Kit

Your paddleboard, powered by your scooter

The SUP Kit turns a WhiteShark Tini into a paddleboard motor. The mount attaches at the rear of the board: nothing to drill, nothing to modify, and the board keeps its balance and feel. Installation is done by hand, without tools, and the kit comes off as fast as it goes on.

The wireless remote goes wherever you want on the board, held by a universal Velcro strap. One trigger is all it takes: start, stop and speed.

One scooter, or two

With a single WhiteShark Tini, the kit pushes the board at 4.5 km/h. With two, you reach 8 km/h. The same mount takes both setups, with no extra part to buy.

The scooters are not included: the SUP Kit is an adapter, made for the Tini units you already own. It is designed for inflatable paddleboards.

Technical specifications

  • Compatibility One or two WhiteShark Tini (not included)
  • Board type Inflatable paddleboard
  • Speed with one Tini 4.5 km/h
  • Speed with two Tini 8 km/h
  • Mounting Rear mount, no drilling or modification
  • Installation No tools required
  • Control Wireless remote, universal Velcro strap
  • Reference KITSUP

Maintenance and care

The SUP Kit is a mechanical part. It is not the electronics that give way, it is the fixings.

  • Check the mount is tight before every launch: vibration works it loose.
  • Inspect the straps and the rubber parts, which take the shocks.
  • Rinse the whole kit with fresh water after use at sea, rails included: that is where salt settles and eventually jams the slide.
  • Store the remote dry, away from the board.
  • Do not leave the kit fitted to a board stored inflated in the sun.

FAQs and helpful articles

Whiteshark Tini

  • What is the speed of the WhiteShark Tini?

    The Tini has 2 speeds: a high speed of 1.4 m/s and a low speed of 1.1 m/s.
    Dual-propeller operation is also optional to reach a top speed of 2.0 m/s. (Dual-propeller operation: low speed 1.6 m/s, high speed 2.0 m/s).

Request a repair